Before connecting the wheel drives to the axle gears, make sure that the retaining rings on the inner joints have been replaced with new ones. This is very important, since when installing old rings, the wheel drives and axle gears may spontaneously separate while the vehicle is moving.
Before installing the gearbox, apply a thin layer of LSC-15 or SHRUS-4 grease to the splined end of the primary shaft and SHRUS-4 grease to the outer surface of the guide sleeve of the clutch release bearing coupling and center the driven clutch disc with mandrel 67.7853.9597 (see figure 76).
Before installing the gearbox control drive, check that the flange of the tip 12 (see figure 78) entered the groove of the cover 9.
After installing the gearbox, adjust the clutch drive (see section. "Clutch") and the gearbox control drive in the following order:
- acting from underneath the vehicle, with the clamping bolt 13 (see figure 78) rods 15 set the gear selection rod 6 to the neutral position;
- install the gear shift lever so that its lower part is positioned perpendicular to the body floor, using device 67.7800.9511 for this purpose. In this position, tighten the nut of the clamp tie bolt 13. Then pour engine oil into the gearbox.
The text is published on the portal: VAZbook.ru