- roulette
- opaque material
Place the car on a flat horizontal platform.
Pre-check and, if necessary, bring the air pressure in the tires to normal.
Check and adjust the headlights on an equipped vehicle: with a fully filled fuel tank, a set of tools and a spare wheel.
Measure the distance from the center of the headlights to the floor on your vehicle. This will be the distance h on the screen.
The headlights are considered adjusted if the upper border of the left parts of the light spots coincides with the line N, and the vertical lines A and B pass through points C1 and C2 intersections of horizontal and inclined sections of light spots.
1. Install the car perpendicular to a smooth wall (e.g. garage) at a distance of 5 m. Place a weight of 75 kg on the driver's seat. Mark the screen on the wall as shown. The longitudinal plane of symmetry of the car must pass along line 0 on the screen.
2. Turn on the low beam.
3. Open the hood and turn the corrector knobs on both headlights to the leftmost position.
4. Adjust with screws 1 (in the horizontal plane) and 2 (in the vertical plane) manual adjustment of the beam of light position of the light spot for each headlight on the screen, if the location of the light spots on the screen does not correspond to the figure (see operation 1).
5. Adjust the direction of the light spot for each headlight separately. Cover the second headlight with an opaque material during adjustment.