2. Raise the front of the car and support it on stands, remove the bolts and remove the wheels.
3. After bending back the petals of the locking plates, unscrew the brake caliper mounting bolts; remove the caliper and set it aside without disconnecting the fluid supply hose to prevent air and dirt from entering the brake hydraulic system; the support should not hang on the pipelines.
4. Remove the front wheel hub cap using puller 67.7801.9514.
5. Unscrew the adjusting nut, remove the washer and use the A.40005/1/9B puller to press off the hub assembly with the brake disc, bearings and seal; remove the hub from the steering knuckle.
Information taken from the website: VazBook.ru
6. After pressing out the hub seal, remove the spacer ring and the inner ring of the inner bearing with the rollers as an assembly.
7. Wash the inside of the hub and bearings.
8. Before installation, fill the bearing separators with LITOL-24 grease. Evenly fill the space between the outer bearing rings along the inner surface of the hub with 40 g of the same grease. Before installing the hub cap, add 25 g of grease.
9. Install the inner race of the inner bearing with rollers in the assembly and the spacer ring into the hub.
10. Press a new seal into the hub using tool 67.7853.9525.
11. carefully, so as not to damage the seal, install the hub assembly with the brake disc on the steering knuckle, then the inner ring of the outer bearing, the washer and tighten the new or used, but on another car, nut.
12. Adjust the hub bearing clearance as described above.