Contents: Removal ↓ Installation ↓
Removal
1. Remove the pressure and driven clutch discs (see items 1-3 "Slave and pressure plates of the clutch - replacement").
2. Using a 17 mm socket wrench, unscrew the six flywheel mounting bolts, holding it from turning with a mounting blade or screwdriver.
3. Remove the washer.
4. Remove the flywheel from the crankshaft.
If necessary, remove the upper clutch housing cover from the guide bushings.
The text is published on the portal [VazBook.ru]
Installation
We install the flywheel and all removed parts on the car in the reverse order of removal.
Before tightening the flywheel mounting bolts, apply thread locking compound to their threaded portion.
The crankshaft is balanced together with the flywheel. Therefore, the flywheel must be installed on the shaft in only one position. For this purpose, there is a mark made by drilling on the outer side of the flywheel.
When installing the flywheel on the crankshaft, the mark should be located opposite the connecting rod journal of the fourth cylinder.
Warning: When installing a new flywheel on a vehicle, it must be balanced together with the crankshaft.