Removing
1. Remove the flywheel (see "Flywheel - removal, installation, replacement").
Warning. When performing the following operation, do not scratch the working surface of the crankshaft.
2. We pry off the rear crankshaft oil seal with a screwdriver...
...and remove it from its seat.
Installation
We apply clean engine oil to the working surface of the new crankshaft oil seal and press it in until it stops with a hammer with a plastic striker.
We install on the car all the removed parts in the reverse order of removal.
Note. You can also press in the crankshaft rear oil seal with an ordinary hammer, using the old oil seal as a mandrel