Contents: Removal ↓ Installation ↓
Removal
1. Remove the throttle assembly from the intake module without disconnecting the hoses.
2. Using a 10 mm head, unscrew the two bracket mounting bolts and move the throttle cable together with the bracket to the side.
3. Remove the high-voltage wire tips from the spark plug wells of cylinders 1, 2, 3, remove the high-voltage wires from the plastic bracket (1) and set them aside without disconnecting them from the ignition module.
Similarly, we disconnect the high-voltage wire of the fourth cylinder from the spark plug and the plastic bracket (2).
The article is copied from the website (www.vazbook.ru)
4. Remove the wire harness holders from the receiver studs and move the harness forward.
Note: To keep the wiring harness out of the way, you can disconnect the harness connector from the crankshaft and camshaft position sensors, and the purge valve of the canister and set it aside.
5. After loosening the clamp, remove the brake booster hose from the intake manifold.
6. Using an 8 mm wrench, loosen the four clamps that secure the rubber couplings to the receiver pipes.
7. Using a 10 mm socket wrench, unscrew the two nuts securing the receiver to the cylinder head cover.
8. Remove the receiver from the engine.
9. If necessary, use a 10 mm socket wrench to unscrew the four bolts and remove the two plastic brackets holding the high-voltage wires.
10. If necessary, use a 10 mm socket wrench to loosen the clamps securing the four connecting sleeves to the intake manifold and remove the sleeves.
Installation
We install the engine receiver and all removed parts on the car in the reverse order.