Removing
1. Remove the throttle assembly from the receiver flange studs without disconnecting the cooling system hoses from it (see "Throttle assembly - removal, gasket replacement and installation").
2. Loosen the clamp (1), remove the vacuum brake booster hose from the receiver pipe.
socket wrench by 10 mm unscrew three nuts (2) throttle cable bracket.
3. Disconnect the tip of the cable from the throttle sector (see "Throttle valve - replacement of the drive cable") and take the throttle cable with the bracket to the side.
4. socket wrench by 13 mm unscrew the five nuts securing the receiver to the intake manifold.
5. Remove the receiver from the engine.
6. We remove the rubber o-rings from the grooves of the receiver flange. Replace damaged rings.
Installation
Install the receiver in reverse order.