key «on 10» unscrew the two bolts securing the throttle cable bracket to the receiver...
...and remove the bracket with the cable.
We remove the throttle assembly from the receiver, without disconnecting the coolant supply and discharge hoses, crankcase ventilation and adsorber purge from the assembly (see Removing the throttle assembly).
Use pliers to loosen the clamp that secures the vacuum brake booster hose to the receiver pipe...
...and remove the hose from the nozzle.
Disconnect the fuel pressure regulator hose.
head «at 13» unscrew the five nuts securing the receiver to the intake pipe.
... and remove the receiver from the pipe studs.
Remove the sealing gasket.
A spacer is installed on the high studs of the inlet pipe.
Install the receiver in reverse order.