Removing
1. Remove the throttle assembly from the receiver flange studs without disconnecting the cooling system hoses from it (see "Throttle assembly - removal, gasket replacement and installation").
2. socket wrench by 10 mm unscrew the two bolts securing the throttle cable bracket.
3. Disconnect the tip of the cable from the throttle sector (see "Throttle valve - replacement of the drive cable") and take the throttle cable with the bracket to the side.
4. Having loosened the clamp, remove the vacuum brake booster hose from the fitting. Disconnect the fuel pressure regulator hose from the receiver.
5. Using a Phillips screwdriver, unscrew the screw (1) and remove the plate securing the fuel pipes. socket wrench by 13 mm unscrew the two nuts securing the bracket.
6. Remove the bracket for fastening the fuel pipes from the receiver studs.
7. socket wrench by 13 mm unscrew the nut securing the receiver to the bracket...
... and five nuts securing the receiver to the intake manifold.
8. Remove the receiver.
9. Remove the gasket from the inlet pipe studs. Replace damaged gasket.
Installation
Install the receiver in reverse order.