Removal and installation bumpers (VAZ-2121)

Bumpers (Fig. 8-22) are made from an aluminum profile, the front wall of which along the entire length of the bumper is finished with a black rubber pad 9, the ends of the bumpers are covered with black plastic pads 6.

Fig. 8-22. Front bumper assembly: 1 - bracket (since 1988 welded to connector 3); 2 - mounting bolt; 3 - connector; 4 - rubber seal; 5 - towing spring; 6 - plastic side cover; 7 - bumper; 8 - pad holder; 9 - rubber pad

Each bumper is attached to the body with two bolts, which must be unscrewed to remove the bumpers.

Install the bumpers in reverse order.

The text is copied from the online portal [VazBook.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The text was reviewed by the specialist: Grigory Vologodtsev

Share with friends:

VAZ-2121: Exterior

Sealing the body with rubber seals and mastics
Restoration of anti-corrosion and anti-noise coating of the underbody and wheel arches
Preparation and anti-corrosion treatment of hidden cavities
Anti-corrosion protection of the body
Painting of individual body parts

More articles from other manuals on VAZ cars:
➠ Removal and installation bumpers VAZ-1111 (1988-1996)
➠ Hood, trunk lid, bumpers — device VAZ-2101 (1970-1983)
➠ Removal and installation bumpers VAZ-21051 (1979-2010)
➠ Hood, bumpers, radiator grille VAZ-2109 (1984-1997)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet