Disassembly
1. Remove the gearshift drive from the car (see "Gearshift drive - removal, installation and adjustment").
2. With a 13 mm wrench, unscrew the nut of the axis of the gear lever.
3. Using a Phillips screwdriver, unscrew the fastening screw and take out the axis of the gear lever.
4. If the axis of the gear lever turns and the nut cannot be unscrewed, then prying with a screwdriver, remove the plastic limiter from the axis.
5. Holding the axis of the gear lever with pliers, unscrew the axle nut.
6. We take out an axis from the lever of a gear change.
7. Supporting the gearshift lever on the edge of the clip, remove the ball end of the lever from the support.
8. We take out from the gear lever two remote...
...and two plastic bushings.
9. Prying with a screwdriver, remove the cover from the support.
10. Having drowned the plastic support of the clip, we take out the retaining ring with thin pliers.
11. We take out the support and the spring.
Assembly
We replace worn parts, assemble and install the gear shift drive on the car in reverse order.