Disassembly
1. Remove jet thrust (see "Jet draft - removal and installation").
If it is planned to install a jet thrust assembly on the car, mark the relative position of the jet thrust and the eye with a marker, felt-tip pen or center punch.
Otherwise, it will be possible to connect the reactive thrust with the eye only after they are installed on the car (separately from each other). In this case, they themselves will take the necessary position.
2. Using two 13 mm wrenches, unscrew the nut of the coupling bolt and unclench the clamp.
3. Disconnect the eye with the bracket from the jet thrust.
4. Using a 13 mm wrench, unscrew the lug fastening nut.
5. Remove the eye from the bracket.
6. Prying off with a screwdriver, we remove the rubber damper from the eye...
...and two plastic bushings.
Assembly
Having replaced the worn bushings and damper, we assemble the jet thrust and install all the removed parts on the car in reverse order.