Cleaning
Before you begin repairing your brakes, rinse them thoroughly with warm water and detergent and dry them immediately with compressed air.
Warning: Do not use gasoline, diesel fuel, trichloroethylene or any other mineral solvents when cleaning brakes, as they will damage the cylinder seals.
Removal
Raise the front of the car, place it on stands and remove the wheel.
Remove the hose guide brackets. Unscrew the bypass bolts, disconnect the hoses 10 (fig. 6-12), while preventing dirt from getting into the cylinder cavities. Plug the inlet holes of the cylinder block and hoses.
After bending the edges of the front brake protective cover, unscrew the bolts securing the brake to the steering knuckle (Fig. 6-13) and remove the brake assembly.
Installation
The front brake is installed in the reverse order of removal.
After installation, restore the brake fluid level in the reservoir and bleed the system to remove air from the hydraulic drive.
(The original can be seen on the website: VazBook.ru)