Contents: Removal ↓ Installation ↓
Removal
First remove the gearbox (see "Transmission"). Loosen the bolts and remove the clutch housing assembly with the pressure plate. In doing so, do not lift this unit by the thrust flange of the pressure spring.
Installation
The clutch is installed in the reverse order, with the following:
- check the condition of the bearing at the end of the engine crankshaft, replace the bearing if necessary;
- check the condition of the splines on the driven disk hub and the primary shaft of the gearbox, clean the splines and lubricate with a thin layer of consistent grease LSC-15 or Fiol-1, Fiol-2;
- install the clutch, positioning the driven disk with the protruding part of the hub with the annular groove towards the gearbox, and center the disk relative to the bearing using the A.70081 mandrel, which imitates the splined end of the primary shaft of the gearbox (Fig. 3-4).
The original is posted on Internet resource vazbook.ru