Attention! We carry out the work on an inspection pit or lift.
Using a 30 mm socket, loosen the bipod mounting nut.
Remove the steering mechanism from the car (see Removal the steering gear and adjusting the clearance in the worm bearings).
The article is copied from the website [VazBook]
Using a puller, we press the bipod off the shaft.
If there is no puller, remove the bipod using the impact method. Rest the bipod shaft against a wooden block.
We press on one bipod stop with a sledgehammer and hit the other with a hammer.
In some cases, it is necessary to cut the bipod with a cutting machine.
The bipod is installed on the conical splines of the shaft in only one position: when the double groove of the bipod and the double spline of the shaft coincide.