Attention! We carry out the work on an inspection pit or lift.
We remove the release spring.
Using pliers, remove the cotter pin from the hole in the pusher.
Using a 13 mm socket head, unscrew the two bolts securing the slave cylinder to the clutch housing.
Using a 22 mm wrench, turn the cylinder by the housing plug, holding the hose tip with a 17 mm wrench.
We disconnect the working cylinder and the hose – the connection is sealed with a copper ring.
The source is on the website: VAZbook.ru
We install the working cylinder in the reverse order. We bleed the hydraulic drive (see Bleeding the clutch hydraulic drive).