To remove the separator, two-way valve of the gas tank, safety and gravity valves, remove the right side panel trim (see Removal interior trim).
Before removing the elements, mark the fittings and hoses.
Using a Phillips screwdriver, unscrew the two screws securing the gravity valve...
...and we take it out of the window of the right side panel of the body.
We loosen the clamps with a Phillips screwdriver.
After removing the hoses,…
...we release the gravity valve.
We disconnect the hoses,…
...we take out the two-way valve.
We pull the safety valve out of the side cavity,...
The material is posted on the website VAZbook.ru
...we loosen the hose clamps...
...and remove the valve.
Using a Phillips screwdriver, unscrew the two screws securing the separator to the body.
We move the separator to the window in the panel...
...and using a Phillips screwdriver, loosen the clamps on the tank ventilation hoses.
Having removed the hoses from the separator fittings,...
...we take it out through the back (the biggest) panel window.
To remove the adsorber, disconnect the electrical connector from it.
Using a Phillips screwdriver, loosen the clamp securing the hose that connects the adsorber to the throttle assembly fitting...
...and remove the hose.
Similarly, we disconnect the hose connecting the adsorber to the two-way valve.
Using a 10 mm spanner, unscrew the bolt that holds the clamp that secures the adsorber to the mudguard.
We remove the adsorber from the engine compartment.
We install the fuel vapor recovery system components in the reverse order.