Attention! We carry out work on an unheated engine.
Disconnect the negative cable from the battery.
Remove the spare wheel support bracket (see Removal the spare wheel pipe and support).
Holding the filter with a 19 mm wrench, use a 17 mm wrench to unscrew the fuel line nipple, gradually releasing the gasoline into a container underneath.
We take the fuel pipe away from the filter. Similarly, we disconnect the fitting of the second pipe.
Each tube has a rubber sealing ring, which is replaced with a new one if damaged.
Using a 10 mm spanner, loosen the clamp tightening bolt...
...and remove the fuel filter.
We install the filter in the reverse order.
The arrow on the new fuel filter should point toward the rear of the vehicle.
Having installed the new filter, we check the tightness of the connections with the engine running.