Figure 175. Front seat (headrest sleeps): 1 - pillow; 2 - back; 3 - headrest guide; 4 — guide pin: 5, 3 — seat base: 6 — smooth backrest tilt adjustment handles; 7 — backrest tilt adjustment handle; 9 - seat runners; 10 — slide latch handle.
The bases 8, 5 of the cushion and seat back are stamped in the form of frames from sheet steel. The base of the back 5 has a pipe to which the guides 3 of the headrest are welded. Wire springs in the form of snakes are attached to the frames of the bases of the backs 8, 5 using metal brackets. Foamed polyurethane padding is installed on the frames. The seat upholstery is made of artificial leather with a synthetic backing to obtain clear decorative patterns.
The seat runners consist of guides 9 (figure 176) and sliders 2 and 6. The sliders can move along guides on two rollers each. Handle 10 has a latch 5, which, under the action of spring 4, enters one of the grooves of lock 11, fixing the required position of the seat. When handle 10 is raised upwards, the latch is released and the seat can be moved.
Figure 176. Front seat runners: 1 - internal guide; 2 - internal slider; 3 - latch axis; 4 — latch spring: 5 — slide latch; 6 - outer slider; 7 — roller; 8 — limiter; 9 - outer guide; 10 — slide latch handle; 11 — retainer.
Smooth adjustment of the seat back tilt is carried out by turning the handle 6 (see figure 175) up and down. For rough adjustment, by acting on handle 7, the driver or passenger presses the backrest to the desired position. To seat passengers in the back seat on the driver's side, lift up (and from the front passenger side they press down) handle 7 for adjusting the backrest tilt and tilt it forward.
To unfold the front seats, move the seat forward and, by lifting up or lowering down the handle 7, lay the seat backs in a comfortable position for rest.
The rear seat consists of a separate cushion and a backrest. The cushion is attached with fixed hinge links to the welded bolts of the body brackets with nuts. The hinges are covered with polyethylene facings. The movable hinge links are attached with bolts to the cushion frame. The rear part of the cushion frame rests on the locking pins. The seat back is connected to the cushion frame at the bottom with hinges, and is locked at the top with two locks. This design allows you to place the seat back on the cushion and, together with the cushion, lift them on the hinges into a vertical position to the backs of the front seats. As a result, the area of the luggage compartment increases.
The information is posted on the portal (VAZBOOK)
The cushion and backrest frames are stamped from sheet steel. The frames are filled with polyurethane foam. The upholstery is made of artificial leather.