When changing the oil, the oil filter should also be replaced, which is removed using tool A.60312 (rice. 2-4). Wrap the filter by hand when installing.
Change the oil in the following order:
- after stopping the engine, drain the used oil and, without removing the oil filter, fill in flushing oil up to the mark «MIN» on the oil level gauge (2.9 l). As flushing oils, oils of the VNIINP-FD, MSP-1 or MPT-2M type can be used;
- start the engine and let it run on this oil for 10 minutes at a low crankshaft speed;
- completely drain the flushing oil and remove the old oil filter;
- install a new filter and fill in the oil corresponding to the season of operation of the car.