Attention! We carry out work on a viewing ditch or a lift.
ring wrench «at 19» we unscrew the nut of the shock absorber lower mounting bolt, holding the bolt from turning with a wrench of the same dimension.
Before removing the bolt with the rear axle beam suspended (when working on a lift), it is necessary to substitute the support under that part of the beam where we remove the shock absorber so that the suspension spring is compressed.
Pulling out the bolt...
... remove the spacer sleeve.
Remove the bolt and washer.
ring wrench «at 19» Loosen the upper shock absorber nut.
We take the puck.
Having removed the upper eyelet from the finger, we take out the shock absorber.
In the lower eye of the shock absorber, two rubber and spacer metal bushings are installed,...
... and at the top there are two rubber bushings.
Install shock absorber in reverse order.
Finally tighten the shock absorber mounting nuts in position «car on wheels».