Attention! We carry out work on a viewing ditch or a lift.
ring wrench «at 19» unscrew the nut of the bolt securing the rod to the body bracket, holding the bolt from turning with a wrench of the same dimension.
We knock out a bolt through a soft metal drift..
...and take it out.
ring wrench «at 19» we unscrew the nut of the bolt securing the rod to the bracket of the rear axle beam, holding the bolt from turning with a head of the same dimension.
We knock out a bolt through a soft metal drift..
... and remove the cross bar.
To replace the cross bar rubber bushings, see Removing the lower longitudinal bar.
Install the bar in reverse order. We finally tighten the nuts of the rod fastening bolts in the position «car on wheels».