Fig. 6-24. Parking brake drive parts:
1 - case; 2 - front cable; 3 - lever; 4 - button; 5 - traction spring; 6 - latch rod; 7 - rear cable guide; 8 - spacer sleeve; 9 - release spring; 10 - spacer bar; 11 - manual brake pad drive lever; 12 - rear cable.
Set the parking brake drive lever to the extreme lower position, disconnect the ends of the cables from the brake shoe drive levers (see "Rear brakes").
Loosen the locknut 5 (fig. 6-4) and adjusting nut 6, remove tension spring 9, then completely unscrew the lock nut and nut.
Remove the front ends of the rear cable from the body floor brackets, and the cable sheath from the rear axle beam brackets and remove rear cable 12.
Remove the shifter boot, then the shifter assembly and front cable.
After removing the cotter pin and thrust washer, disconnect the front cable from the parking brake drive lever.
Install the parking brake in the reverse order of removal, and then adjust it (see "Adjusting the parking brake"). When installing, lubricate the rear cable guide, the parking brake lever axle and the front cable tip with Litol-24 or LSC-15 grease.
(Information taken from the website VAZbook)