- open the hood and disconnect the wire from the outlet «minus» battery;
- remove the instrument panel shield, to do this, unscrew the two screws securing it from below, and then pull the lower edge of the shield towards you and release the upper latches;
- unscrew the two fastening nuts and remove the instrument cluster from the instrument panel socket;
- disconnect from a combination of devices of a wire and a flexible shaft of a drive of a speedometer.
Install the instrument cluster in the reverse order of removal. During installation, avoid loops and bends of the flexible shaft, leading to permanent deformation of its shell. After installing the instrument cluster, the flexible shaft must not have sharp bends. The bending radii of the shaft shell in the mounted state must be greater than 100 mm.