head «at 22» unscrew the bolt securing the towing eye and the bumper connector to the left front side member.
Remove the eyelet and bolt.
Similarly, we disconnect the fastening of the towing eye and the bumper connector to the right side member.
Shaking, we pull the bumper connectors from the seals of the lower cross member of the front end.
Prying off with a screwdriver..
... remove the rubber seal from the hole in the lower cross member.
To remove the rear bumper..
... head «at 22» unscrew the bolt securing the bumper connector to the right rear side member..
... and remove the bolt.
Similarly, unscrew the bolt securing the bumper connector to the left rear side member. We remove the rear bumper and rubber seals in the same way as the front ones.
To remove the rear towing eyelets..
... head «at 17» loosen two bolts..
... and remove the eyelet.
The front and rear bumpers are disassembled in the same way - we show on the example of the front.
To remove the connector..
... head «at 13» loosen two screws..
... and remove the connector.
To remove the plastic side trim..
... use a Phillips screwdriver to unscrew the four screws..
... and remove the cover.
To remove the rubber pad..
... head «for 8» loosen four screws..
... and remove the cover.
To remove the metal bracket..
... head «at 13» unscrew the two nuts, holding the bolts with a wrench of the same dimension,..
... and remove the bracket.
We assemble and install the bumper in reverse order.