Attention! We work on a cold engine.
Open the heater tap.
Unscrew the radiator cap.
We substitute the container and prepare the hose with an inner diameter of 16 mm.
In the lower left corner of the radiator...
... unscrew the cork...
... and through the hose we drain the liquid from the radiator.
To drain the fluid from the engine...
...with a spanner «at 13» unscrew the plug on the left side of the cylinder block...
... and drain the liquid by pressing the same hose against the hole in the block.
To drain the expansion tank, disconnect its mount (see Removing the expansion tank). We open the cork and, lifting the tank, drain the coolant through the radiator.
We wrap the drain plugs, return the expansion tank to its place.
Pour coolant through the radiator up to the upper edge of the filler neck.
Pour liquid into the expansion tank to a level 3-4 cm above the MIN·mark.
We start the engine, add fluid. We warm up the engine with a closed radiator cap.
After cooling the coolant, check its level.
Top up if necessary.