Remove an upholstery of racks of a wind window, a facing casing of a steering column, a guard 14 (pic. 8-28) instrument panels, instrument cluster (see section «electrical equipment») and disconnect the pads and plugs of the vehicle electrical wiring harness.
Pic. 8-28. Dashboard and its accessories:
1 - mounting bracket; 2 - amplifier; 3 - instrument panel; 4 - glove box body; 5 - lid lock latch; 6 - glove box cover; 7 - lock spring; 8 - cover lock; 9 - shelf; 10 - hinge link of the cover; 11 - a box for small things; 12 - fastening brackets; 13 - radio receiver mounting panel; 14 - instrument panel shield.
After removing the handle of the instrument lighting switch, unscrew the fastening nut and drown the switch behind the instrument panel.
Turn out screws of fastening, remove a ware shelf 9 and the panel 13 of fastening of a radio receiver; disconnect the wires from the radio, cigarette lighter, wiper and headlight washer switch, alarm switch.
Turn out screws of fastening and remove the case 4 of a ware box.
Remove the handles from the heater control levers, for which, at the junction of the handle with the lever, bend the lower part with a flat sharp tool near the upper handle, and the upper part at the middle and lower handles.
Remove four screws (in fig. 8-29 screw locations are shown by arrows) the lower fastening of the instrument panel 3 to the cross member of the front end, and through the openings of the glove box and the instrument panel shield, unscrew the four nuts of the upper fastening of the panel to the front end, then remove the instrument panel.
If necessary, remove the central and side nozzles with interior ventilation air ducts from the instrument panel.
Install the panel in reverse order.