Attention! We carry out work on a lift or a viewing ditch.
Removing the right front wheel drive (see Removing the front wheel drives).
Remove the retaining ring with pliers.
Remove the spring washer.
With a hammer with a plastic striker, we knock down the bearing cover of the inner hinge housing together with the bearing from the shaft.
We remove the bearing.
Using pliers, we remove the adjusting ring from the groove of the outer ring of the bearing.
Remove bearing cap with seal.
To replace the front axle mounting bracket..
…remove it.
Tool head of suitable diameter (suitable length of pipe) knock out the seal..
... and take it out of the lid.
Having lubricated the surface of the new oil seal with Litol-24 grease, we press it into the cover with a suitable piece of pipe.
We assemble and install the assembly in the reverse order.
Similarly, we replace the bearing and oil seal of the inner joint housing of the left drive.
Attention! The oil seal of the inner joint housing of the left drive is different from the oil seal of the right drive.