Attention! We carry out work on a lift or a viewing ditch.
Drain the oil from the front axle gearbox (see Changing the oil in the front axle gearbox).
Disconnect the propeller shaft from the front axle gearbox (see Removing the cardan shaft).
Dismantling the right drive (see Removing the front wheel drives).
Disconnect the left lower ball joint from the lever (see Removing the lower ball joint).
Removing the left front suspension bracket (see Stretch Removal).
ring wrench «at 13» we unscrew the three nuts securing the bearing cover of the inner hinge housing of the left drive to the front axle gearbox.
We pry off the bearing cover with a mounting spatula...
... and, pulling the steering knuckle with the drive to the left, we remove the splined part of the body of the internal hinge of the drive from the hole in the gearbox housing.
We take the body of the internal hinge of the drive back.
We put an emphasis under the gearbox.
ring wrench «at 19» unscrew the two nuts securing the gearbox:
to the cylinder block..
...and to the left engine mount bracket.
Removing the stop from under the gearbox,..
…remove it.
Install the gearbox in reverse order.