Loosen the locknut 5 (fig. 6-4) and adjusting nut 6, remove tension spring 9 (Fig. 6-24), then completely unscrew the lock nut and nut.
Fig. 6-24. Parking brake drive parts: 1 - case; 2 - front cable, 3 - lever; 4 - button; 5 - traction spring; 6 - dog pull; 7 - rear cable guide; 8 - spacer sleeve, 9 - release spring; 10 - spacer bar; 11 - manual brake pad drive lever; 12 - rear cable
Remove the front ends of the rear cable from the body floor bracket crowns, and the cable sheath from the rear axle beam brackets, and remove rear cable 12.
Remove the lever boot, then the lever assembly and front cable
After removing the cotter pin and thrust washer, disconnect the front cable from the handbrake drive lever.
Install the parking brake in the reverse order of removal, and then adjust it (see "Adjusting the parking brake"). When installing, lubricate the rear cable guide, the parking brake lever axle and the front cable tip with LITOL-24 or LSC-15 consistent grease.