Two keys «for 8» loosen the bolt securing the drive cable to the carburetor choke control lever.
key «for 8» loosen the bolt securing the clamping bracket of the cable sheath...
...and remove the rope.
In the cabin, we take out the handle of the air damper drive and disconnect the cable from it.
Removing the instrument cluster (see Removing the instrument cluster).
Through the socket in the instrument panel, use pliers to remove the locking bracket of the cable end.
Prying off with a screwdriver, we take out the rubber cable seal from the hole in the front end shield..
... and pull the seal off the cable sheath.
We take out the cable.
Install the cable in reverse order.
When installing the cable, we orient the tip so that its flat is aligned with the flat of the hole in the instrument panel.
We install the locking bracket into the slot of the cable end.
When completely «recessed» handle, the choke must be fully open. If necessary, we adjust the drive by moving the cable sheath with the bolt securing the clamping bracket of the cable sheath loosened.