Attention! It is performed when replacing the carburetor, as well as when the drive parts are worn or replaced.
With the pedal fully depressed «gas» throttle valves should be fully open, and when released - closed.
If this is not the case, disconnect the tip of the longitudinal drive rod from the bracket on the valve cover (see Removing the carburetor from the engine).
key «for 8» loosen the lock nut (for clarity, the operation is shown on the removed rod).
By unscrewing or wrapping the tip, we achieve the correct adjustment. Tighten the locknut.
We also check the distance between the centers of the tie rod ends, which should be 80 mm.
If the adjustment range is not enough (shutters do not open fully), bend up the pedal «gas».