Make sure that there are no extraneous noises and knocks when the engine is running.
Check the tightness of the fasteners of the power unit supports (see table. 8.1.2).
Make sure there are no engine oil leaks through the engine seals and oil seals (see "Engine - check of technical condition").
Change engine oil and oil filter (see "Lubrication system - oil and oil filter change").
Make sure there are no coolant leaks, check the condition of the hoses and the radiator of the engine cooling system (see "Cooling system - check of technical condition").
Check fuel lines and hoses for leaks (see "Power supply system - check of technical condition").
Check functionality (by the presence of fault codes) engine management systems (see "Engine management system - check of technical condition").
Check the tightness of the exhaust system and the condition of the muffler suspension parts (see "System of release of the fulfilled gases - check of a technical condition").
Make sure there is no extraneous noise when engaging and disengaging the clutch (see "Clutch - checking the technical condition").
Check tightening and, if necessary, tighten the fastening of the camshaft covers (see "Camshaft - removal and installation") *.
Adjust thermal gaps in the gas distribution mechanism (see "Adjusting clearances in the timing valve drive") *.
Check clutch pedal travel (see "Clutch release actuator - adjustment").
Check that there are no transmission oil leaks from the transmission seals and oil seals (see "Gearbox - check of technical condition").
Check the condition of the protective covers of the hinge and gearshift drive rod (see "Gearshift drive - removal, installation and adjustment").
Check the clarity of gear shifting, make sure that there are no extraneous noises and knocks in the operation of the gearbox (see "Gearbox - check of technical condition").
Make sure that there are no extraneous noises in the hinges of the front wheel drives when the vehicle is moving straight and when cornering (see "Front wheel drives - check of technical condition").
Check the condition of the protective covers of the hinges of the front wheel drives (see "Front wheel drives - check of technical condition").
Check the condition of tires and rims (see "Wheels, tires and hubs - checking the technical condition").
Check and, if necessary, balance the wheels (see "Wheels, tires and hubs - checking the technical condition").
Make sure that there are no extraneous noises in the front and rear suspension when the car is moving over bumps (see "Front suspension - check of technical condition" And "Rear suspension - check of technical condition").
Check the condition of the front and rear suspension parts (see "Front suspension - check of technical condition" And "Rear suspension - check of technical condition").
Check and, if necessary, adjust the wheel alignment (see "Front wheel alignment - check").
Check the condition of the protective covers of the steering rods and steering gear (see "Steering - check of technical condition").
Make sure there are no brake fluid leaks, check the condition of the hoses and tubes of the hydraulic brake system (see "Brake system - check of technical condition").
Check the operation of the parking brake (see "Brake system - check of technical condition").
Check the efficiency of all brake mechanisms (see "Brake system - check of technical condition").
Make sure the generator is working (see "Generator - check").
Make sure that the lamps of the lighting system and light signaling are in good condition (see "Lighting, light and sound signaling").
Check the operation of the headlight hydrocorrector (see "Lighting, light and sound signaling").
Make sure the warning lights on the instrument panel are working (see "Instrumentation and sensors").
Make sure the sound signal is working (see "Lighting, light and sound signaling").
Check the serviceability of the wipers and windshield washers in all operating modes (see "Windshield wipers and washers").
Check the electrically heated rear window (see "Governing bodies").
Check the operation of the power windows and exterior mirrors (see "Governing bodies").
Check the operation of the heated seats (see "Governing bodies").
Make sure the door and hood locks are working properly (see "Body - check of technical condition").
Check the health of the heater (see "Interior ventilation and heating system").
2. After every 15,000 km of vehicle run, all operations must be performed (except for those noted "*"), performed with a run of 2500 km, as well as:
Check the condition and tension of the timing belt (see "Timing belt - checking the condition and adjusting the tension").
Check the coolant level in the expansion tank of the engine cooling system (see "Cooling system - check of technical condition").
Check the oil level in the gearbox (see "Gearbox - oil level check").
Check steering play (see "Steering - check of technical condition").
Check the brake fluid level in the master cylinder reservoir (see "Brake fluid level in the master cylinder reservoir - check").
Check the degree of wear of the front brake pads (see "Brake pads - wear check").
Check the condition and tension of the alternator drive belt (see "Alternator drive belt - condition check and tension adjustment").
Check the level and density of the electrolyte in the battery (see "Battery - service").
Lubricate hinges and door stops (see "Body maintenance").
Clean drain holes in doors and sills (see "Body maintenance").
Replace the filter element of the cabin ventilation system (see "Ventilation and heating system filter - replacement").
3. After every 30,000 km of the car, it is necessary to perform all the operations performed during the run of every 15,000 km, as well as:
Replace the fuel filter of the engine power supply system (see "Fuel filter - replacement").
Replace air filter element (see "Air filter - filter element replacement").
Replace spark plugs (see "Spark plugs - check and replacement").
Check the degree of wear of the rear brake pads (see "Brake pads - wear check").
Check the operation of the pressure regulator of the hydraulic drive of the brake system (see "Rear brake fluid pressure regulator - adjustment").
Clean and lubricate battery terminals and leads (see "Battery - service").
Lubricate door and hood locks (see "Body maintenance").
4. After every 45,000 km of the vehicle, it is necessary to perform all the operations performed every 15,000 km, as well as:
Adjust thermal gaps in the gas distribution mechanism (see "Adjusting clearances in the timing valve drive").
Change the brake fluid in the hydraulic drive of the brake system (see "Hydraulic brake drive - changing the brake fluid").
Check the operation of the vacuum brake booster (see "Vacuum brake booster - check").
Clean manifold, check for wear and lubricate starter drive parts (see "Starter - repair").
Adjust headlight beam direction (see "Block headlight - light adjustment").
Lubricate the hood latch cable (see "Hood lock drive rod - replacement").
5. After every 60,000 km of the car, it is necessary to perform all the operations performed during the run of every 15,000 km, as well as:
Clean the slip rings and check the degree of wear of the generator brushes (see "Voltage regulator - check and replacement").
6. After every 75,000 km of the car, it is necessary to perform all the operations performed during the run of every 15,000 km, as well as:
Replace the timing belt (see "Timing belt - replacement").
Change the coolant in the engine cooling system (see "Coolant - replacement").
Replace oxygen sensor (see "Oxygen concentration sensor - check and replacement").
Change gearbox oil (see "Gearbox - oil change").