Attention! We carry out work on a viewing ditch or a lift.
To dismantle the pillow of the right suspension support of the power unit...
...with a spanner «at 17» unscrew the nut securing the pillow to the engine mount bracket (alternator removed for clarity).
ring wrench «at 17» unscrew the nut securing the pillow to the cross member bracket.
We remove the thickened washer.
We substitute the adjustable stop under the generator bracket and raise the power unit.
Squeezing the pillow with a mounting blade, we remove its pin from the hole in the engine mount bracket...
...and remove the pillow of the right support.
Similarly, we remove the pillow of the left support of the power unit. Wherein:
... we unscrew the nut for attaching the pillow to the cross member bracket with the head «at 17»,...
... and we substitute the support under the crankcase mounting bolt (From the left side).
We remove the pillow of the left support of the power unit.
If there are cracks, tears or peeling of rubber on the support pads, replace the pads with new ones.
We install the pillows of the left and right supports of the power unit in reverse order.
When installing the pillow, the centering collar of the stud (located on one side of the pillow)...
...must fit into the appropriate hole in the cross member bracket.
To remove the rear support of the power unit...
...with a spanner «at 17» loosen the bolt securing the support to the cross member of the rear suspension of the power unit.
head «at 13» unscrew the four nuts securing the cross member to the body.
Having finally unscrewed the bolt securing the support to the cross member,...
... take it out.
head «at 13» unscrew the two nuts securing the support bracket to the rear cover of the gearbox.
We take out the support.
To dismantle the cross member of the rear suspension of the power unit, remove it from the studs, turn it and remove its left edge from behind the front driveshaft.
Remove the cross member of the rear suspension of the power unit.
We install the cross member and the rear suspension support of the power unit in the reverse order.