Attention! We carry out work on a viewing ditch or a lift.
Remove the oil pan protection plate and the engine mudguard.
Drain the oil from the engine (see Engine oil change).
We unscrew the nuts securing the pillows of the left and right supports of the power unit to the brackets of the front suspension cross member (see Removing the power unit supports).
We disconnect the fastening of the front axle gearbox to the suspension brackets of the power unit and the engine block (see Removing the front axle gearbox).
Substituting an adjustable stop under the clutch housing,..
... raise the power unit.
To fix the power unit...
... we insert wooden bars between the pillows of the supports and the suspension brackets...
...and lower the adjustable stop.
head «on 10» unscrew the nineteen bolts securing the oil pan to the cylinder block.
We lower the oil pan.
We remove the gasket of the oil pan from under the intake pipe of the oil pump and the guide tube of the oil level indicator.
We remove the lining.
Having cleaned the mating surfaces of the cylinder block and the oil pan, install a new gasket. We assemble in the reverse order.