We remove the windshield wiper to replace the gearmotor or deformed parts of the lever drive.
To remove the harness..
... the key «on 10» unscrew the nut of its fastening.
Shaking, remove the leash.
If the leash comes off tight..
... you can use the key «at 17», acting as a fork puller.
To remove the windshield wiper, remove both leashes.
key «at 21» unscrew the nut securing the lever bushing to the body.
We remove the equalizer..
...and a rubber gasket.
Similarly, we release the sleeve of the other lever.
In the engine bay..
... disconnect the gearmotor block.
head «on 10» unscrew the two nuts securing the cleaner bracket to the body.
We lower the cleaner down to remove the bushings from the holes in the body, while removing the bracket from the studs..
... and bring the windshield wiper assembly to the right side of the car from under the hood lock bracket (for clarity, the air intake box is removed).
To remove the gearmotor from the windshield wiper bracket..
... the key «on 10» unscrew the nut securing the crank to the gearmotor shaft..
... and, prying with a screwdriver, remove the crank.
key «on 10» unscrew the three bolts securing the gearmotor to the bracket..
... and disconnect the bracket and gearmotor.
We assemble the windshield cleaner in reverse order.
Attention! Having attached the gearmotor to the bracket, we connect the gearmotor block to the vehicle wiring and turn it on for a short time. We turn off the gearmotor with the lever of the steering column switch and wait until the gearmotor shaft stops. Now on the shaft, which has stopped in this position,..
... we put on the crank so that it is parallel to the lever of the cleaner mechanism.