Disconnect the wire connectors from the low brake fluid level sensor.
Unscrew the plug and remove the level sensor.
key «on 10» unscrew the two nuts securing the tank bracket to the body.
We remove two brackets from the right stud «massive» wires.
We remove the bracket from the studs.
We take out the hoses from the plastic holder.
Tilt the reservoir and drain the brake fluid into a container.
We loosen the fastening clamps with pliers..
... and remove the hoses from the tank fittings.
Install the tank in place in reverse order. Top up the brake fluid and bleed the hydraulic drive (see Bleeding the brakes).
To check the low brake fluid level sensor, turn on the ignition and lower the parking brake lever.
We press a finger on the rod protruding from the tank lid.
The control lamp for applying the parking brake and insufficient brake fluid level in the instrument cluster should light up. When the rod is released, the lamp should go out.