Attention! We carry out work on a viewing ditch or a lift.
Removing the brake drum (see Replacing the rear brake pads).
To replace the wheel cylinder, remove the brake pads or remove their stops from the slots of the cylinder pistons by sliding the pads down (see Replacing the rear brake pads - the second way).
key «on 10» (or a special wrench covering five faces of the nut) unscrew the brake pipe fitting.
We remove the tube from the hole in the wheel cylinder.
To avoid loss of brake fluid, we put on the protective cap of the bleeder fitting at the end of the tube.
ring wrench «on 10» unscrew the two bolts securing the cylinder to the brake shield..
... and remove the wheel cylinder.
Install the wheel cylinder in reverse order. After installing the pads and the brake drum, we pump the brake system (see Bleeding the brakes).