Attention! We install the car on a viewing ditch or lift.
We hang out the rear axle of the car and lower the parking brake lever to the lower position.
Holding the adjusting nut with a wrench «at 13», loosen the locknut with the same wrench.
Holding the tip of the cable with pliers, a key «at 13» tighten the adjusting nut.
You can also hold the tip of the cable at the point of its connection with the spring, by clamping its end with pliers.
In this case, the full travel of the parking brake lever should be 4–5 teeth of the ratchet sector. With the lever fully down, the wheels should turn freely without binding. In this position, tighten the locknut.
To remove the front cable and the parking brake lever, lower the lever to the lower position.
We remove the retractable spring.
Two keys «at 13» unfasten the nuts.
Holding the tip of the front cable with pliers, high head «at 13» Loosen the adjusting nut and locknut at the same time.
Remove the spacer from the tip of the front cable.
Remove the rear cable guide.
We take out the cotter pin with pliers,..
... remove the thrust washer..
... and disconnect the front cable from the parking brake lever.
In the cabin, use a Phillips screwdriver to unscrew the screw on the side fastening of the lever casing..
...and a rear mount screw.
Remove the lever cover.
Remove the sealing gasket.
head «on 10» unscrew the four bolts securing the arm bracket to the floor.
Remove the parking brake lever.
To remove the rear cable for the parking brake system, disconnect its tips from the levers of the manual drive of the rear pads (see Replacing the rear brake pads).
Remove the rear cable guide.
We shift the protective rubber cap from the tip of the cable sheath.
Using a screwdriver, we move the tip of the cable sheath..
... and remove it from the hole in the body bracket.
With pliers we unbend the lug of the bracket of the rear axle beam..
... and we bring out the cable.
key «on 10» unscrew the two bolts securing the cable sheath holder to the brake shield.
We remove the tip of the cable from the hole in the brake shield.
In the same way, we release the other end of the rear cable.
Remove the rear parking brake cable.
Install the cable in reverse order. Adjusting the parking brake system.