Attention! The operation is carried out when replacing the ball joint or cover (anther) ball finger.
Hang and remove the front wheel.
head «at 22» unscrew the nut securing the ball joint to the steering knuckle.
Removing two clamps (pressure plates) brake hose fittings.
Install the stop under the lower arm.
key «at 13» unscrew the nut of the ball joint bolt to the upper arm, holding the bolt from turning with a wrench of the same dimension.
We unscrew the nuts of two more bolts.
We take out the bolts and remove the steering knuckle with the ball joint from the upper arm.
Using a puller, press the ball joint pin out of the steering knuckle hole.
Remove the ball joint.
In the absence of a puller, by unscrewing the ball joint mounting nut, remove the brake hose clamps. We compress the spring with a stop installed under the lower arm. We insert a bar between the upper arm and the rebound buffer bracket. We bait the nut of the ball joint pin. We remove the focus.
By striking with a hammer on the eye of the steering knuckle, we press out the pin of the ball joint from the hole of the steering knuckle.
Having unscrewed the nuts of the bolts securing the ball joint to the upper arm and the nut of the support pin, remove the ball joint.
Removing the pressure plate..
…and a protective cover for the ball stud.
When installing a new ball pin cover, we put SRB-4 grease in it. We assemble and install the ball joint in the reverse order.