head «at 19» unscrew the nuts of the two bolts securing the lever to the cross member bracket.
We hold the bolts from turning with a wrench of the same dimension (generator removed for clarity).
Remove the lever assembly with the axle.
Washers are installed on the bolts between the axle and the cross member bracket to adjust the angles of the longitudinal inclination of the axis of rotation and the camber of the front wheels.
Clamping the axis of the lever in a vise,..
... the key «at 22» Loosen the two axle nuts.
Remove the thrust washer.
To press out silent blocks, we install a puller on the lever so that..
... its cup rested on the end of the eye of the lever, and the bolt of the puller is screwed onto the axle with an internal thread.
Tightening the puller bolt nut (while holding the bolt from turning),…
... we press out the silent block from the lever.
Having removed the silent block from the axle, we install it in the eyelets of the lever and press out the second silent block with a puller.
In the absence of a puller,..
... prying the outer bushing of the silent block with a chisel,...
... we press it out.
To install new silent blocks..
... with a cup puller, we press one silent block into the eye of the lever.
Before pressing the second silent block, we clamp the lever in a vise, insert the axle with thrust washers into the eyelets of the lever and screw the nut onto the axle from the side of the pressed silent block. We insert the second silent block into the eye hole.
We insert a mandrel made from a suitable piece of pipe into the gap between the eyes of the lever (160 mm long, 42 mm inside diameter, 32 mm slot width).
We rest the cup of the puller against the end of the outer sleeve of the silent block.
By screwing the bolt of the puller onto the axis of the lever, we press in the silent block.
In the absence of a puller, we rest the end of the eye of the lever on the vise jaws.
We press the silent block with a tool head of a suitable size (pipe section).
Install the lever in reverse order.
The nuts for fastening the silent blocks on the axle are finally tightened in the position «car on wheels».