Attention! We carry out work on a viewing ditch or a lift.
We dismantle the driven and leading clutch discs (see Replacing the driven and master clutch discs).
We screw the gearbox mounting bolt into the threaded hole in the cylinder block.
head «at 17» Loosen the six flywheel bolts. We hold the crankshaft from turning with a mounting blade inserted between the teeth of the flywheel and resting on the screwed bolt.
Removing the plate...
...and a flywheel.
head «on 10» unscrew the two nuts securing the clutch housing cover...
...and take it off.
Pry off the seal with a screwdriver...
... remove it from the holder.
Lubricate the working edge of the new oil seal with engine oil.
Using the old oil seal as a mandrel, press in the new oil seal.
Install the dismantled parts in reverse order.