Programming the alternate engine start procedure
Programming of the alternative engine start procedure is carried out in the following sequence:
- 1. Set the immobilizer to «Reading» by turning the key in the ignition switch. At the same time, the lamp «CHECK ENGINE» lights up with a constant light.
- 2. Bring «mine» red code key to the status indicator and, while holding it, turn off the ignition. After the LED lights up and the buzzer gives a short beep, remove the code key. Approximately 3-5 seconds after the ignition is turned off, the LED will flash at a frequency of 10 times per 1 second, alternating with short breaks.
- 3. Bring the red key back to the status indicator. In this case, the LED will switch to the constant glow mode and the buzzer will give a short beep. After that, take the code key.
- 4. Not later than 10 s after the LED lights up with constant light, turn on the ignition. If everything is done in time, the LED will start flashing at a frequency of 5 times in 1 s, and the control lamp «CHECK ENGINE» - with a frequency of 1 time in 2 s.
- 5. After 4 min the lamp «CHECK ENGINE» goes out for 1 minute. During this one-minute interval, periodically press the accelerator pedal all the way down to enter a number from 1 to 9. Each time you press the accelerator pedal, the lamp «CHECK ENGINE» lights up and the number increases by one. This number must be remembered. After 1 min the lamp «CHECK ENGINE» returns to flashing mode.
- 6. Perform step 5 five times in a row. Moreover, when performing each stage of entering numbers (1 to 9) their meanings may differ from each other. Numerical values and the sequence of their water also need to be remembered. In the event that you do not press the accelerator pedal, the programming process stops.
- 7..After the minute allotted for entering the sixth number, turn off the ignition.
- 8. After 20 seconds, turn on the ignition. If the lamp «CHECK ENGINE» lights up permanently, the programming of the alternative start was successful.
Alternative engine start procedure
To start the engine in the event of a malfunction of the immobilizer or the loss of a working code key, you must perform the following steps:
- 1. Turn on the ignition. At the same time, the lamp «CHECK ENGINE» lights up permanently and stays on for 4 minutes.
- 2. After four minutes, the lamp goes out for 1 minute. Within a minute interval, by pressing the accelerator pedal all the way, enter the memorized number. Each press on the pedal increases the number by one and is accompanied by the lamp lighting up «CHECK ENGINE». After the minute allotted for entering the number, the lamp «CHECK ENGINE» lights up again.
- 3. Perform step 2 five times in succession, each time entering the numerical values in the sequence you have programmed. If the accelerator pedal is not depressed or an incorrect number is entered, the alternate start procedure is aborted and the controller remains locked. This is indicated by a flashing light «CHECK ENGINE» with a frequency of 3 times in 2 s.
- 4. After the minute allotted for entering the sixth number, it is necessary to start the engine without turning off the ignition.
After the engine is stopped, the controller is blocked again after 15 seconds. The engine can be restarted if less than 15 seconds have elapsed since the ignition was switched off. If more than 15 seconds have passed since the ignition was turned off, the engine cannot be started. In this case, it is necessary to reprogram and then perform the alternative engine start procedure.